11–Fibre Channel Over Ethernet
FCoE Boot from SAN
3.
Ensure DCB/DCBX is enabled on the device
only supported on DCBX capable configurations. As such, DCB/DCBX must
be enabled, and the directly attached link peer must also be DCBX capable
with parameters that allow for full DCBX synchronization.
Figure 11-2. FCoE Boot<Variable>—Enable DCB/DCBX
4.
On some platforms, you may need to set the boot protocol through system
BIOS configuration in the integrated devices pane as described above.
For all other devices, set the Boot Protocol field to FCoE in the MBA
Configuration Menu
Figure 11-3. FCoE Boot<Variable>—Select FCoE Boot Protocol
(Figure
11-3) through CCM.
218
(Figure
11-2). FCoE boot is
83840-546-00 D