8–Using QLogic Control Suite
Managing the LAN Device
NOTE
Clicking Reset after clicking Defaults, but before clicking Apply, will
Apply must be clicked to make changes go into effect.
Any changes to existing settings will be lost upon clicking Defaults.
You must have administrator privileges to change the property values.
The list of available properties for your adapter may be different.
Some properties may not be available for all QLogic network adapters.
If an adapter is included as a member of a team and you change any
Figure 8-9. QCS—Configure NDIS-level Parameters
Configuration Tab: Advanced
Ethernet@Wirespeed Enables a Gigabit Ethernet adapter to establish a link at
a lower speed when only two pairs of wires are available in the cabling plant. The
default setting for this property is Enabled.
purge all values.
advanced property, then you must rebuild the team to ensure that the
team's advanced properties are properly set.
114
83840-546-00 D