Table of Contents
Advertisement
OWC Mercury On-The-Go Pro
➇
Here you see the OWC Mercury On-The-Go Pro drive inserted into the acrylic enclosure,
ready to have it's end cap attached.
➈
Insert the acrylic endcap, fully sliding it over the bridge card ports.
Once you have the endcap on, attach it to the enclosure using the 2 included small
Phillips screws. The location is circled above. You will have 4 larger screws remaining, they
are extra.
Do not exert too much force while screwing these in, you can accidentally strip the screw
head easily.
Chapter 2 - System Setup
Advertisement
Table of Contents
Need help?
Do you have a question about the Mercury On-The-Go Pro Series and is the answer not in the manual?
Questions and answers