Raid Scanning - Buffalo LinkStation LS-VL User Manual

Using your LinkStation

RAID Scanning

LinkStations that are in RAID 1, RAID 5, RAID 10 modes support RAID scanning. A RAID scan tests the
RAID array for read performance. If defective sectors are found, they are repaired automatically. If
your multiple-drive LinkStation is in RAID 1 mode, you should run RAID scans regularly. Configure
regular RAID scans as follows:
1
2
Notes: Check [Shutdown] to automatically shut down the LinkStation whenever a RAID error
occurs. Check [Begin Immediate RAID Scan] to initiate an immediate RAID scan.
To stop a RAID scan, click [Abort RAID Scanning].
Single-drive LinkStations do not support RAID arrays or RAID scanning.
RAID Scanning is now configured.
LinkStation User Manual
Navigate to [System] - [Storage] - [RAID Scanning]
in the Web Admin interface. Under [RAID
Scanning], click [Modify Settings].
Choose [Enable], enter your desired schedule, and
click [Save].
95