Buffalo LinkStation LS-VL User Manual page 192

Appendix
Function LED
Status Descriptions
When installing a USB device
Solid Blue
When the USB device is recognized, the Function LED is lit blue (for about 60 seconds).
After the Function LED is lit blue, the USB device can be accessed.
When removing a USB device
To remove a USB device connected to the LinkStation, hold down the Function button for at least
three seconds. The LED turns solid blue. Once the solid blue of Function LED turns off, remove
the USB device.
When starting DirectCopy
After the USB device is connected, pressing the LinkStation Function button while the Function
LED is solid blue (about 60 seconds) copies the data from the USB device to the DirectCopy folder.
During execution of DirectCopy
Blinking Blue
The LED flashes blue during the DirectCopy operation. Pressing the Function button again during
the DirectCopy operation cancels it.
During LinkStation setting initialization
Turning on the Power button while holding down the Function button causes the LED to flash
blue (for 1 minute). Pressing the Function button while the LED is flashing blue performs the
initialization process.
LinkStation User Manual
Function LED
191