Buffalo LinkStation LS-VL User Manual page 179

Appendix
Error code
E01
E02
E03
E04
E06
E07
E10
E11
E15
E16
E17
E20
E21
E22
E23
LinkStation User Manual
Descriptions
Problem in DRAM DATA LINE. Contact Buffalo tech support for assistance.
Problem in DRAM ADDRESS LINE. Contact Buffalo tech support for assistance.
Problem in RTC CHIP. Contact Buffalo tech support for assistance.
Kernel extraction failed. Contact Buffalo tech support for assistance.
The firmware is corrupted. Contact Buffalo tech support for assistance. Wait 5 minutes
for "E04", then shut down the unit. Or, turn the power switch off.
No hard drives detected. If the hard drives are connected normally, contact Buffalo
technical support for assistance.
Operating from UPS battery. The LinkStation will be shut down normally. After the
LinkStation shuts down, ensure that power is supplied to the UPS. If there is no
problem, briefly press the LinkStation's function button to reset. Do not hold down
the function button too long or you may get unexpected results.
Fan Error. The fan is spinning too slowly or has stopped. Move the unit to a cool place
with good airflow and no objects blocking the fan. If the LED remains lit, replace the
fan with part OP-FAN/LS, sold separately.
Hard drive IO error. Contact Buffalo tech support for assistance.
The hard disk is not connected or is malfunctioning. Contact Buffalo tech support for
assistance.
Internal controller error. Contact Buffalo tech support for assistance.
The circuit board may be damaged. Disconnect and then reconnect power. Reboot
the LinkStation. If the error persists, contact Buffalo technical support for assistance.
Internal controller error. Contact Buffalo tech support for assistance.
Drive mount error. Contact Buffalo technical support for assistance.
The hard drive may be damaged. Contact Buffalo technical support for assistance.
178