Buffalo LinkStation LS-VL User Manual page 189

Appendix
E07
E10
E11
E12
E13
E14
E15
E16
E17
E18
E19
E20
E21
E22
E23
LinkStation User Manual
No hard drives detected. If the hard drives are connected normally, contact Buffalo
technical support for assistance.
Operating from UPS battery. The LinkStation will be shut down normally. After the
LinkStation shuts down, ensure that power is supplied to the UPS. Check the power
supplied to the UPS, and if there is no problem, turn on the power for the LinkStation.
Fan Error. The fan is spinning too slowly or has stopped. Move the unit to a cool
place with good airflow and no objects blocking the fan. If the LED still turns on,
contact Buffalo technical support for assistance.
The system temperature has exceeded the safety value. Check that there are no
objects around the LinkStation, or install at a cooler location.
An error occurred in the RAID array. Operation will continue, but in degraded mode.
Replace the failed drive as soon as possible. After replacement, rebuild the RAID array
by following the setup screen after starting the LinkStation.
The RAID array cannot be mounted. If the same error appears after turning the power
off and then on again, rebuild the RAID. If the error still appears, contact Buffalo
technical support for assistance.
The invalid sectors of the hard drive have reached a dangerous level. Replace the
hard drive indicated by the red Status LED.
The hard disk is not connected or is malfunctioning. Contact Buffalo technical
support for assistance.
The circuit board may be damaged. Disconnect and then reconnect power. Reboot
the LinkStation. If the error persists, contact Buffalo technical support for assistance.
The circuit board may be damaged. Disconnect and then reconnect power. Reboot
the LinkStation. If the error persists, contact Buffalo technical support for assistance.
The circuit board may be damaged. Disconnect and then reconnect power. Reboot
the LinkStation. If the error persists, contact Buffalo technical support for assistance.
The circuit board may be damaged. Disconnect and then reconnect power. Reboot
the LinkStation. If the error persists, contact Buffalo technical support for assistance.
The circuit board may be damaged. Disconnect and then reconnect power. Reboot
the LinkStation. If the error persists, contact Buffalo technical support for assistance.
Mounting of the hard drive failed. Format the hard drive. If the error still appears after
formatting and restarting, replace the hard drive. If the error still appears, contact
Buffalo technical support for assistance.
An error occurred, and the hard drive was removed from the RAID array. Replace the
hard drive indicated by the red Status LED.
188