Buffalo LinkStation LS-VL User Manual page 190

Appendix
Power LED flashing amber
The Power LED flashes amber with information codes. The way it flashes indicates the message.
Note: If the Power LED is flashing amber, you can open NAS Navigator2. It will tell you the status of
the LinkStation.
Place
10s place
1s place
Information code
I10
I11
I12
I13
I14
I15
I16
I17
I18
I20
I21
I22
I23
LinkStation User Manual
Status
The LED illuminates for 1.0 seconds every 0.3 seconds.
The number of flashes is the tens place of the information code.
The LED illuminates for 0.5 seconds every 0.3 seconds.
The number of flashes is the ones place of the information code.
Descriptions
The internal temperature of the LinkStation has exceeded the allowable value. Do
not place objects in the area around the LinkStation, or install at a cooler location.
The invalid sectors of the hard drive have reached a dangerous level. Replace the
hard drive indicated by the red Access LED.
The RAID array is being degraded mode.
The RAID array is being formatted.
The RAID array is being checked.
The error status of the RAID array is being investigated.
Data transfers will be slower than usual until this is complete.
The RAID array is being created.
The RAID array is being resynchronized.
Data transfers will be slower than usual until this is complete.
The RAID array is being reconfigured.
Data transfers will be slower than usual until this is complete.
Formatting the hard drive.
Checking the hard drive.
Data is being completely erased by writing 0s to the hard drive.
Initializing the system settings
Power LED
189