Controlling User Access; G.shdsl Commands; To Establish The Dsl Link - Patton electronics 3201 User Manual

D • Command Line Interface (CLI) Operation

Controlling user access

To set user access for user username, use the command (all on one line):
system set user < username > access {default|engineer|superuser}

G.SHDSL Commands:

Command format: 'gshdsl Action Attribute Value'
• Action – Two types of actions are available: 'set' or 'show'
• Set – set attributes with a value.
• Show – get information from the box
• Attribute – The name of the attributes to access.
• Value – The new value for the attribute (Set command only)
Example: To read the attribute 'Version':
To set data rate to 256K (4 * 64K):
To set terminal type to CPE mode:
To show the current terminal type:
Attribute Type Value
Version RO -
Platform RO -
ModemState RO
Idle
Deactivated
Norm Oper
In-Progress
DSLRateTS RW 3-36
DataRateI RW 0-7
terminal RW Central
Remote
Interface RW Hdlc
Action WO Start
Deactivate

To establish the DSL link

1. One unit needs to be set to CO (central) and the other unit as CP (remote)
2. The Data rate of the 2 units have to be the same (DatarateN)
124
gshdsl show Version
gshdsl set DSLRateTS
gshdsl set terminal remote
gshdsl show terminal
The version number of the DSL driver
The platform name of the unit e.g. 3201 or 3201
Show the state of the handshaking process:
Idle – The DSL chip is in idle state
Deactivated – The DSL chip is deactivated
Normal Operation – The DSL chip is in operating (Link established)
In-Progress – Handshaking in process
Data rate N number N=3-36. e.g. 256K data rate is N=4. The composite data
rate is the chosen number N times 64 kbps. E.g., 32 x 64 kbps = 2.048 Mbps.
This attribute controls the size of the overhead channel. Valid input is 0-7. Default
value is 0. (!!Keep it as 0)
Central – CO unit
Remote – CPE unit
Utopia – Data will be packaged in ATM cell format and send through the UTOPIA
interface of the processor
Hdlc – Data will be packaged in HDLC frame and send through the PCM Bus
Start – Command the box to configure the DSL chip and start the handshaking process
Deactivate – Command the box to disconnect and deactivate the DSL link.
Model 3201 G.SHDSL Integrated Access Device User Guide
Description
Administering user accounts