USER MANUAL MODEL 1000P Non-Powered Short Haul Modem Part #07M1000PA SALES OFFICE Doc. #022031UA (301) 975-1000 Revised 2/17/98 TECHNICAL SUPPORT C E R T I F I E D (301) 975-1007 An ISO-9001 http://www.patton.com Certified Company...
NOTE: When power is removed from the DCE or DTE to which the Model 1000P is connected, the 1000P can no longer send a signal to the remote receiver. Under this condition, the idled cable is susceptible to noise reception. The remote receiver may output erroneous...
Page 3
Pins 6, 8 and 20 are tied together 2.0 DESCRIPTION The Model 1000P has the option of being configured as either DCE or DTE The Model 1000P Asynchronous Short Range Modem uses the latest devices. Set the switch located on the top of the printed circuit board to the DCE or...
The Model 1000P meets the requirements for FCC Part 15 (RFI limits for Class A FEMALE MALE peripheral devices). RS-232 PINS Connection (Male 2 (RXB) or Female) 1 2 3 4 5 6 3 (TXB) 4 (TXA) DCE/DTE Switch 5 (RXA)
Page 5
Plug the unit’s interface connector end into the RS-232C connector on the DTE or DCE, and tighten the connector mounting screws. For examples of typical applications of the Model 1000P with DTE or DCE devices, refer to Figure 6, below.