Related Manuals for Patton electronics 1202
Summary of Contents for Patton electronics 1202
-
Page 1: User Manual
USER MANUAL MODEL 1202 High Speed Synchronous Modem Eliminator Part# 07M1202-A SALES OFFICE Doc# 049012UA (301) 975-1000 Revised 7/5/95 TECHNICAL SUPPORT (301) 975-1007... - Page 2 Supporting selectable data rates of 16, 32, 64, 128, 256 and 512 Kbps, the Model 1202 needs no AC power or batteries for operation. The Model 1202 provides internal or external 1.2 SERVICE...
-
Page 3: Carrier Detect
The default setting is 6.6mS for both ports. 3.4 GROUND The ground strap setting connects the protective ground from port 1 or 2 to the Model 1202’s signal ground. The default setting is port 1. Figure 1. Strap settings for the Model 1202... -
Page 4: Installation
After the Model 1202 is properly installed, it should operate transparently—as if it were a standard cable connection. Operating 2. Turn off the computer or device to which the Model 1202 is to be power is derived from the RS-232 data and control signals; there is no connected. -
Page 5: Appendix Aspecifications
APPENDIX A APPENDIX B SPECIFICATIONS BLOCK DIAGRAM Data Rates: Strap selectable for 16, 32, 64, 128, 256 or 512 Kbps Clocking: Strap selectable for Internal or external clock Grounding: Protective ground (pin 1) may be strapped to signal ground (pin 7) Range: 75 feet on either side (for a total of 150 feet) at 64 Kbps, range extends linearly for lower bit rates and decreases for higher bit rates...