Table of Contents
Advertisement
Alphanumeric Entry
You can use the Keypad button to directly enter a Setup ID number. Press the Keypad
button and enter the ID number using the alphanumeric data entry buttons, then press the
Enter button to confirm it. The Keypad button's LED is lit when the button is active and
remains lit until you press the button again to disable it.
Value Jump Buttons
Pressing the Next and Previous buttons simultaneously resets the parameter to its default
value.
Param Jump Buttons
Pressing the Chan / Param Up (
jumps parameters to specific jump points. The jump points are: Local Program, Transpose,
Low Key, ModWheel Destination, Slider1 Destination, Slider6 Destination, Slider11
Destination, Foot Switch Destination, Aux Effect Override (Common).
Intuitive Entry (Easy Selection)
In Edit Setup Mode, pressing the Select button with a button or controller performs easy
selection in the following cases:
Select + Zone (1–4) Button
Pressing the Select button with one of the four Zone buttons selects that Zone but leaves
the current parameter being edited on the display. If the parameter is a Setup common
parameter and not a Zone parameter, it will not do anything.
Select + controller
Pressing the Select button with a controller (a slider, Sw button, Mod Wheel or any pedal)
jumps to the first parameter of the selected controller in the current Zone. If you are
entering a number (alphanumeric entry) and press Enter, this action will apply the chosen
number.
̂
) and Chan / Param Down (
Edit Setup Mode
Selecting Parameters
̌
) buttons simultaneously
8-5
Advertisement
Table of Contents
