Table of Contents
Advertisement
Headphones
Connecting Pedals
Plug your switch or continuous control pedals into the corresponding jacks on the SP5's rear
panel. We recommend using the Kurzweil pedals described in Pedals (Optional) on page 1-2,
but you can use almost any switch or continuous control pedal that adheres to the following
specifications (as most pedals do):
The pedals are independently assignable within each Zone of every setup. Here are the
default settings for the three pedals you can use with the SP5:
NOTE: Be sure not to step on the switch pedals when powering up your Stage Piano!
SP5 connected to a mixer, powered speakers and headphones
Right Mixer In
Left Mixer In
Right
Audio
Left
Out
Audio
Out
Switch pedals
Continuous Control (CC)
pedals
Switch Pedal 1
Switch Pedal 2
CC Pedal
SP5
1/4-inch tip-sleeve (mono) plug
10-kOhm linear-taper potentiometer, 1/4-inch tip-
ring-sleeve (stereo) plug with the wiper connected to
the tip
Controller 64 (Sustain)
Controller 66 (Sostenuto)
Controller 11 (Expression / Volume)
Getting Started
Connecting Pedals
Right Mixer Out
Left Mixer Out
Left
Speaker
Right
Speaker
2-5
Advertisement
Table of Contents
