Table of Contents
Advertisement
In the Save Dialog, there are two parameters available which allow you to specify the ID
number and rename the Program. Use the first parameter to change the ID number and the
second to rename the Program. While the Save button LED is blinking, press one of the
Chan / Param buttons to switch between the two parameters.
Changing ID Numbers
To change the ID number, turn the Alpha Wheel or use the Value buttons to select the
number. You can also use the secondary alphanumeric functions of the Category buttons, to
type in a ID number, then press the Enter button. Note that if you select a number out of
range (greater than 1087) and press the Enter button, the ID number won't change.
Naming a User Program
To rename the Program, first press one of the Chan / Param buttons to change the
parameter. You should see the following in the display:
The bottom line of the display shows the current Program name. Note that by default
the first character is selected and the cursor is under it. New Program names can total 16
characters in length. (Note that Program names that are 16 characters in length cause the
ID number and Program name to scroll marquee-style in the display.) Use the secondary
alphanumeric functions of the Category buttons to enter the new Program name.
Press the Previous or Next button to move the cursor. Press the +/- button to switch
between upper and lower case characters (all characters will be upper case until you press
the +/- button again). Use the Space button to change the current character to a space, the
Insert button to insert a blank space (all the characters to the right will move one space to
the right), and the Delete button to delete the current character (all the characters to the
right will move one space to the left).
Saving a User Program
When you finish changing the ID number and naming the Program, the Save button LED
should still be blinking. Press the Save button to complete the process. Saved User Programs
have an asterisk between the ID number and Program name.
Rename Prog as:
Pro Pi ano
_
Prog Xpose:0
1024*My Program
Program Mode
User Programs
2/2
Ch:1
6-11
Advertisement
Table of Contents
