The Destination Parameter Determines The Midi Cc Controller Number That; On Value; Off Value; Entry State - Kurzweil Forte Manual

Multi Edit Mode
CONTROLS Page
The Destination parameter determines the MIDI CC controller number that a physical con-
troller will send to the Program in the currently selected Zone. By default, these CC messages
are also sent to the MIDI Out and USB ports on the Channel of that Zone.

On Value

The On Value is the MIDI value sent when a switch controller is set to On. You can set this
parameter to any number between 0 and 127, or to None.

Off Value

The Off Value is the MIDI value sent when a switch controller is set to Off. You can set this
parameter to any number between 0 and 127, or to None.

Entry State

The Entry State parameter determines the state of the Foot Switch or button that is sent as a
MIDI message when the current Multi is loaded. You can set this parameter to None, On, or
Off. This parameter is common to all Zones.
None can be entered with the alphanumeric function of the Category buttons as -1.
If Entry State is set to None, then when you load the current Multi, no value will be
transmitted. If you specify an Entry State, then a MIDI controller message with this value
will be sent when you load the current Multi.

Exit State

The Exit State parameter determines the state of the Foot Switch or button that is sent as a
MIDI message when the current Multi is exited. You can set this parameter to None, On, or
Off. This parameter is common to all Zones.
None is entered with the alphanumeric function of the Category buttons as -1.
If Exit State is set to None, then when you leave the current Multi by selecting another Multi
or Program, the Foot Switch or button will remain at whatever value corresponds to its
current position. If you specify an Exit State, then a MIDI controller message with this value
will be sent when you select a different Multi or Program.

Velocity

The Velocity parameter only appears if the Mode is set to "Chord" and is for use with switch
controllers. Use the Velocity parameter to select a MIDI attack velocity (0-127) for the
note(s) designated in the Key1 to Key8 field(s.) Alternatively, set the Velocity field to Auto
and the note's velocity will be the velocity set by the KeyVel Multi Destination (see KeyVel
on page 11-25).
11-19