Table of Contents
Advertisement
System Mode
System Mode Buttons
System Mode Buttons
The Value and Chan/Param buttons perform the following functions in System Mode:
Run SP5
This is the first System Mode menu item. Pressing the Next button will load the OS and the
SP5 will start up as if you just switched on the unit (except for the
happens when you first start up the unit).
Update Software
Update Software has two parameters: Update and Restore. Select Update to install a new OS
and Objects version, or select Restore to the install the previous OS version. The new OS
and Object files are combined in one file (.KUF).
Update
1. Obtain the Update file from the Kurzweil website or another reliable source and save it
in a known folder or directory on your computer.
2. Connect the SP5 (powered off) to your computer with a USB cable.
3. Follow the instructions specified on page 10-1 to enter System Mode. The SP5 will
appear as a removable disk/drive on your computer.
4. Press the Chan / Param Up (
5. Press the Next button once. The display shows
10-2
Previous
Next
Chan / Param Up
Chan / Param Down
Use the Previous button to return to the previous
menu. Similar to a "cancel" button.
Use the Next button to confirm a selection and move
into sub-menu if any. Like an "OK" button.
Use the Chan / Param Up button to select the next
menu item, menu item parameter or read Diagnostic test
messages.
Use the Chan / Param Down button to select the
previous menu item, menu item parameter or read
Diagnostic test messages.
̂
) button once. The display shows
message that
.
.
Advertisement
Table of Contents
