Kurzweil SP5-8 Musician's Manual page 107

Tutorials
Controlling Multiple Modules with a Single Setup
4. Let's now set the following Zone-specific parameters thusly (note that "Unassigned
5. Let's now set the MIDI receive channels on each of the Modules in our rig. Note that
6. Finally, let's now save our newly-created Setup. To save our Layer Setup, press the
11-10
Number" means a MIDI controller number that is unassigned on the target Module):
Zone 1
Parameter
Channel
MIDI Bank
MIDI Program
Low Key
High Key
Foot Switch Destination
Foot Switch Mode
Foot Switch Entry State
Foot Switch Exit State
All Other Controller Destinations
All Other Controller Entry States
All Other Controller Exit States
Zone 3
Parameter
Channel
MIDI Bank
MIDI Program
Low Key
High Key
Slider 1 Destination
Slider 1 Entry State
Slider 1 Exit State
All Other Controller Destinations
All Other Controller Entry States
All Other Controller Exit States
they will be the same as the channels of their corresponding Zone:
Module
Module 1
Module 2
Module 3
Module 4
Save button once. The Save button's LED begins to blink and the Keypad button's
LED lights.
Zone 2
Value Parameter
1 Channel
2 MIDI Bank
3 MIDI Program
C6 Low Key
G7 High Key
64 Mod Wheel Destination
Momentary Mod Wheel Entry State
Off Mod Wheel Exit State
All Other Controller Destinations
Off
Unassigned All Other Controller Entry States
Number
0 All Other Controller Exit States
0
Zone 4
Value Parameter
3 Channel
3 MIDI Bank
67 MIDI Program
C3 Low Key
E4 High Key
7 Slider 1 Destination
127 Slider 1 Entry State
127 Slider 1 Exit State
All Other Controller Destinations
Unassigned
Number
0 All Other Controller Entry States
0 All Other Controller Exit States
Channel
1
2
3
4
Value
2
5
112
F4
B5
1
0
0
Unassigned
Number
0
0
Value
4
0
23
E1
B2
7
127
127
Unassigned
Number
0
0