Safety Measures - Compak R-80 Instruction Manual

10.3. Grinding group maintenance
To effect grinding group maintenance work, the following instructions
should be followed:
Turn the front setting dial (4) all the way to the left. Turn the machine off,
using the ON-OFF switch (12). Disconnect the cable from the power
supply. Remove hopper (2) from upper body (3) according to section 7.
Dismantle upper body (3), by unscrewing the two rear screws.
Remove the 4 setting screws (a) of the upper burr holder from the
grinding cup (Allen wrench 4), according to Fig. 8.
(b)
Replace the burrs by unscrewing them from their upper and lower
supports. During this operation, it is recommended to block the
rotation of the lower burrs with a flat-head screwdriver. Clean the
coffee remains from burr holders. Take out the used burrs and put in
the new ones. Assemble to setting screws (a) of the upper burr holder
to the grinding cup.
10.4. Reset the burrs to the 0 position
(the point in which the burrs no longer touch)
Turn the front dial (4) clockwise until the burrs are as close as possible
without touching. Loosen, with the help of the key wrench that comes
with the grinder, the screw (b), until the chain is released. Turn the front
dial (4) clockwise as far as possible. Tighten the screw (b). Assemble the
upper body (3), tightening the two rear screws and replace the hopper.
(a)
(a)
(a)
(a)
Fig. 8
11

Safety measures

NOTE: The manufacturer cannot accept responsibility for any damage
caused by improper use of the machine or failure to respect the safety
measures indicated.
Users are asked to pay careful attention to the following indications:
• The coffee grinder should only be used for grinding coffee beans.
• Do not use the machine to grind other types of foods such as nuts,
dried fruits or to fine-grind granulated foods such as sugar, etc.
• Do not allow minors or disabled people to use the machine.
!
• Any other use of the machine will be considered improper and
dangerous.
• Do not allow liquids to come into contact with the internal or external
surfaces of the machine at any time, except for those parts that have
been expressly referred to in section 9. If, for any reason, this should occur,
immediately disconnect the machine from the power supply and dry all
surfaces carefully. Should it be necessary to access the internal parts of the
machine, where the electrical components are located, take the machine
to your local technical service.
• In the event of any broken components or intervention, we recommend
that you contact your local technical service, who will repair or replace
the part, guaranteeing the maintenance of the safety standards.
• Replacement of the main power cable of any grinder model should only
be done by an authorized supplier.