IBM pSeries 7311 D10 Service Manual page 153

8. Select Unconfigure a Device and press Enter.
Note: If the adapter or device has a problem that prevents it from being replaced by hot-plug, it must
be replaced by shutting down the system. Go to "Adding or Replacing a Non-Hot-Pluggable
PCI Adapter" on page 132.
9. Press F4 to display the Device Names menu.
10. From the menu, select the adapter you are removing.
11. Use the tab key to answer YES to Keep Definition and YES to set Unconfigure Child Devices.
Press Enter.
12. The ARE YOU SURE screen displays. Press Enter to verify the information. Successful
unconfiguration is indicated by the OK message displayed next to the Command field at the top of the
screen.
13. Press F3 to return to the PCI Hot-Plug Manager menu.
14. Select List PCI Hot-Plug Slots and press Enter.
Note: If the List PCI Hot-Plug Slots menu indicates that the slot for the adapter you intend to replace
or reseat is empty, do the following:
a. Press F3 to cancel.
b. Select Add PCI Hot-Plug Adapter, and press Enter. The display screen indicates that the PCI
slot is empty.
c. On the display screen, select the indicated empty slot. Examine at the adapter you intend to
replace or reseat. A slow blinking amber LED located on the PCI riser card is indicating that the
slot has been identified. Press Enter. The adapter is now in the action state.
d. Completely remove the hot-plug adapter from the slot. The LED goes off.
e. Reinstall the adapter, ensuring that it is correctly seated. Press Enter.
f. Press F3 to return to the "PCI Hot-Plug Adapter Menu".
g. Connect the appropriate cables and devices to the adapter.
h. Select List PCI Hot-Plug Slots, then press Enter.
i. Return to the error code or procedure that sent you here, if the "List PCI Hot-Plug Slots" menu
indicates that the slot for the just-replaced or reseated adapter is empty.
15. Press F3 to cancel.
16. Select Replace/Remove a PCI Hot-Plug Adapter, then press Enter. The "Replace/Remove a PCI
Hot-Plug Adapter menu displays.
Note: If the PCI Hot-Plug Adapter menu indicates that the slot for the just replaced adapter is
reading empty, do the following:
a. From the Replace/Remove a PCI Hot-Plug Adapter menu, press F3 to cancel.
b. Select Add PCI Hot-Plug Adapter, and press Enter. The display screen indicates that the PCI
slot is empty.
c. On the display screen, select the indicated empty slot. Examine at the adapter you intend to
replace. A slow blinking amber LED located on the PCI riser card is indicating that the slot has
been identified. Press Enter. The adapter has been put into the action state.
d. Completely remove the hot-plug adapter from the slot. The LED goes off.
e. Reinstall the adapter, ensuring that it is correctly seated. Press Enter.
f. Press F3 to return to the PCI Hot-Plug Adapter Menu.
g. Select Install/Configure Devices Added after IPL.
h. At the display screen, identify the PCI hot-plug slot that your adapter is using. If it still shows as
being empty, redo steps a through g. However, before you reinstall the adapter, test it. If the
adapter fails the test, redo steps a through g with a new adapter.
Chapter 3. Removal and Replacement Procedures
137