Handling Static-Sensitive Devices; Stopping And Starting The System; Removal And Replacement Procedures For The Model D10 I/O Subsystem; Model D10 Fru Replacement Procedure List - IBM pSeries 7311 D10 Service Manual

Handling Static-Sensitive Devices

Attention: Electronic boards and disk drives are sensitive to static electricity discharge. These devices
are wrapped in antistatic bags to prevent this damage.
Take the following precautions:
v If you have an antistatic wrist strap available, use it while handling the device.
v Do not remove the device from the antistatic bag until you are ready to install the device in the system.
v With the device still in its antistatic bag, touch it to a metal frame of the system.
v Grasp cards and boards by the edges. Hold drives by the frame. Avoid touching the solder joints or
pins.
v If you need to lay the device down while it is out of the antistatic bag, lay it on the antistatic bag. Before
picking it up again, touch the antistatic bag and the metal frame of the system at the same time.
v Handle the devices carefully to prevent permanent damage.

Stopping and Starting the System

For procedures to power the system on and off, refer to the service guide of the processor subsystem to
which the I/O subsystem is attached.
Removal and Replacement Procedures for the Model D10 I/O
Subsystem
The following procedures cover the removal and replacement of the Model D10 I/O Subsystem FRUs.
Note: Before performing any of the removal or replacement procedures in this chapter, read the danger
and caution notices on "Safety Considerations" on page 41.

Model D10 FRU Replacement Procedure List

Field Replaceable Unit (FRU)
Adapters
Bezel
Cover
Blower
I/O Backplane
Operating Position
Power Supplies
RIO Bus Adapter
Service Position
Static-Sensitive Devices
Stopping and Starting the System
42 Eserver pSeries 7311 Model D10 and Model D20 Service Guide
FRU Procedure Name and Page Location
"PCI Adapters" on page 45
"D10 Front Bezel" on page 43
"D10 Covers" on page 44
"D10 Fan" on page 108
"D10 I/O Backplane Assembly" on page 110
"D10 Operating Position" on page 43
"D10 Power Supply" on page 111
"D10 RIO Bus Adapter Assembly" on page 109
"D10 Service Position" on page 43
"Handling Static-Sensitive Devices"
"Stopping and Starting the System"