IBM pSeries 7311 D10 Service Manual page 108

q. Using the system documentation, determine if the adapter you are installing is hot-swappable. If
the adapter is hot-swappable, move the slider on the color indicator to allow the orange to be
visible. If the adapter is not hot-swappable, the blue color is visible.
r. The adapter is ready to be installed into a system or an I/O drawer.
Long Adapter Installation: Use the following procedure to install a long adapter.
Note: Ensure that both the retaining arms for the long and short adapters are removed from the cassette
linkage. Before continuing, see step 1a on page 70 to remove the arms.
1. Install the long adapter by doing the following:
a. Place the adapter into the cassette so that the upper left corner of the adapter engages the top
adjustable adapter-retaining clip as shown in the following figure:
92 Eserver pSeries 7311 Model D10 and Model D20 Service Guide
1
1 Orange for Hot-Swappable
2
2 Blue for Not Hot-Swappable