Page 2
Creative is a trademark of Creative Technology LTD. CHRONTEL is a trademark of Chrontel Inc. All other product names or trademarks are properties of their respective owners. Part No. 2006334210 Edition 1 Printed in China Nov. 2008 PCM-3342 User Manual...
Page 3
ADVANTECH Repair Service Department. For those products which are not DOA, the return fee to an authorized ADVANTECH repair facility will be at the customers’ expense. The shipping fee for reconstructive products from ADVANTECH back to customers’ sites will be at ADVANTECH’s expense.
Discard used batteries according to the manufacturer's instructions. Technical Support and Assistance For more information about this and other Advantech products, please visit our web- site at: http://www.advantech.com/ http://www.advantech.com/ePlatform/ For technical support and service, please visit our support website at: http://support.advantech.com.tw/support/...
Packing List Before installation, please ensure the following items have been shipped: Item Part Number 1 PCM-3342 SBC 1 Startup manual 1 Utility CD 1 mini jumper pack Cables Part Number Description 1700060202 1 PS/2 Y-Cable 1700260250 1 LPT port cable...
Introduction The PCM-3342 is a PC/104 SBC (Single Board Computer) with low power usage based on the Advantech EVA-X4150 SoC (System on Chip). The PCM-3342, in con- junction with the EVA-X4150 SoC and onboard 64MB SDRAM, supports two USB 2.0 compatible ports, one 10/100Mbps Ethernet interface and TTL interface, and one PC/104 expansion connector.
Advantech EVA-X4150 SoC and SMSC SCH 3114 supports (LPC Super I/O) 2 full function serial ports by EVA-X4150 SoC 2 full function serial ports by SMSC SCH 3114 High Speed NS16C550A Compatible UARTs with Data rates to 1.5 Serial ports...
Power Supply Voltage Voltage requirement with AT Power: +12 VDC +/-5% +5 VDC +/-5% 1.3.3.2 Power Supply Current Supply Current (Typical) CPU: Advantech Em’Core EVA-X4150 RAM:133 MHz 64 MB SDRAM 12 V 3.3 V 1.19 A 1.3.3.3 RTC Battery Typical Voltage: 3.0 V Normal discharge capacity: 300 mAh 1.3.4...
Chapter H/W Installation This chapter explains the setup procedures of the PCM-3342 hard- ware, including instructions on setting jumpers and connecting peripherals, switches, indicators and mechanical drawings. Be sure to read all safety precautions before you begin the installation procedure.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have any doubts about the best hardware configuration for your application, contact your local distributor or sales representative before you make any changes. Generally, you simply need a standard cable to make most connections. PCM-3342 User Manual...
AT Power Input Reset Battery 24 bits TTL Panel Inverter Power Output Internal USB SATA CN10 HDD & PWR LED CN11 CN12 CN13 RS-422/485 CN14 GPIO CN15 CN16 CN17 PC104 CN18 ISA -5 V & -12 V Input PCM-3342 User Manual...
Power Connector (CN1, CN2) Main power connector, +5 V, +12 V (CN1) Supplies main power to the PCM-3342 (+5 V), and to devices that require +12 V. Reset connector (CN2) Momentarily pressing the reset button connected to reset connector will activate a reset.
Page 17
2.2.2.12 PC/104 Connector (CN17) PCM-3342 supports full ISA compatible functions via PC/104 connector (CN17). 20 x 2 (F) 2.54 mm 51.86 mm x 5.01 mm x 11.45 mm p = 3.40 mm 32 x 2 (F) 2.54 mm 82.34 mm x 5.01 mm x 11.45 mm p = 3.40 mm PC/104 negative voltage: One 3 * 1P pin header (CN18) supports -5 V/-12 V power input for ISA devices.
CPUs from 386 through Pentium and AMD Geode, K7 and K8 (including multiple pro- cessor platforms), and VIA Eden C3 and C7 CPU. You can use Advantech’s utilities to select and install features to suit your designs for customers need.
Set Password Establish, change or disable password. Save & Exit Setup Save CMOS value settings to CMOS and exit BIOS setup. Exit Without Saving Abandon all CMOS value changes and exit BIOS setup. PCM-3342 User Manual...
Extended Memory The POST of the BIOS will determine the amount of extended memory (above 1 MB in CPU’s memory address map) installed in the system. Total Memory This item displays the total system memory size. PCM-3342 User Manual...
This item allows a user to set baud rate modes. Agent Connect via [NULL] This item allows a user to set agent connect modes. Agent Wait Time(min) [1] This item allows a user to set agent wait time (min). PCM-3342 User Manual...
This item allows a user to set watch dog timer. Do CMOS Clear [Disabled] This item allows a user to clear CMOS. I/O Cycle Control [Disabled] This item allows a user to set I/O cycle control mode. CPU Fast Decode Cycle [Normal] PCM-3342 User Manual...
This item allows user to adjust primary master IDE mode of type for modifica- tion purpose. The Bios default value is set to “Auto”. Slave UDMA [Auto] This item allows user to adjust primary slave IDE mode. The Bios default value is set to “Auto”. IDE HDD Block Mode [Enabled] PCM-3342 User Manual...
Page 28
IRQ. Parallel Port Mode [Standard] Select an operating mode for the onboard parallel port. ECP Mode Use DMA [3] When the onboard parallel is set to ECP mode, the parallel port can use DMA3 or DMA1. PCM-3342 User Manual...
3.2.6 PC Health Status Note! This entry displays the current system temperature, and voltage. Current SYS Temperature 1.8 V 12 V 3.2.7 Load Optimized Defaults PCM-3342 User Manual...
Load Optimized Defaults loads the default system values directly from ROM, for use if the stored record created by the Setup program should ever become corrupted (and therefore unusable). These defaults will load automatically when you turn the PCM-3342 sys- tem on. 3.2.8...
Page 31
Select Set Password again, and at the “Enter Password” prompt, please don’t enter anything; just press <Enter>. At the “Confirm Password” prompt, again, don’t type in anything; just press <Enter>. Select Save to CMOS and EXIT, type <Y>, then <Enter>. PCM-3342 User Manual...
Typing "Y" will quit the BIOS Setup Utility and save user setup value to CMOS. Typing "N" will return to the BIOS Setup Utility. 3.2.10 Quit Without Saving Note! Typing “Y°” will quit the BIOS Setup Utility without saving to CMOS. Typing “N” will return to the BIOS Setup Utility. PCM-3342 User Manual...
After applying force to the IPC connector, the footprint of the module / CPU board needs to be inserted correctly. After applying force to the connector, the footprint of the module / CPU board needs to be inserted correctly. PCM-3342 User Manual...
Part Number 1655004110 Footprint WF_4P_98_A2544WR2-4P_R1_D Description WAFER 2.54 mm 4P 90D MALEW/LOCK Pin Name +12 V +5 V Reset (CN2) Reset Part Number 1655302020 Footprint WHL2V-2M Description WAFER BOX 2P 180D (M) 2.0 mm W/Lock Pin Name RESET# PCM-3342 User Manual...
Battery (CN3) Battery Part Number 1655902032 Footprint WHL2V-125 Description WAFER 2P 180D (M) 1.25 mm DIP 53047-0210 Pin Name +3 V CF (CN4) PCM-3342 User Manual...
Page 38
Part Number 1653000106 Footprint COMPACK-T12 Description CF HEADER 50P 90D (M)SMD typeII N7E50-H516RA-50 Pin Name CS0# +5 V CD2# CD1# PCM-3342 User Manual...
Page 39
Part Number 1653000106 Footprint COMPACK-T12 Description CF HEADER 50P 90D (M) SMD typeII N7E50-H516RA-50 Pin Name CS1# VS1# IORD# IOWR# IREQ +5 V CSEL# VS2# RESET IORDY INPACK# REG# DASP# PDIAG# PCM-3342 User Manual...
VGA (CN5) Part Number 1653208260 Footprint BH8X2SV Description BOX HEADER 8 * 2P 180D (M) 2.00 mm Pin Name GREEN BLUE DDAT HSYNC VSYNC DCLK PCM-3342 User Manual...
24-bit TTL Panel 24-bit TTL Panel Part Number 1653920200 Footprint SPH20X2 Description *CONN. 40P 90D 1.25 mm SMD WO/Pb DF13-40DP-1.25 V Pin Name +5 V +5 V +3.3 V +3.3 V PD10 PD11 PD12 PD13 PD14 PD15 PD16 PD17 PCM-3342 User Manual...
PD22 PD23 SHFCLK FLM (V-SYNC) M/DE LP (H-SYNC) ENVEE Inverter Power Output (CN7) Inverter Power Output Part Number 1655305020 Footprint WHL5V-2M Description WAFER BOX 2.0 mm 5P 180D (M) W/LOCK Pin Name +12 V ENABKL +5 V PCM-3342 User Manual...
Internal USB Internal USB Part Number 1653005260 Footprint HD_5x2P_79_N10 Description PIN HEADER 5 * 2P 180D (M) 2.0 mm SMD FOOLPROOF Pin Name +5 V +5 V A_D- B_D- A_D+ B_D+ PCM-3342 User Manual...
HDD & PWR LED (CN10) CN10 HDD & PWR LED Part Number 1653004101 Footprint JH4X1V-2M Description PIN HEADER 4 * 1P 180D (M) 2.0 mm DIP WO/Pb Pin Name Power LED+ Power LED- HDD LED+ HDD LED- PCM-3342 User Manual...
A.11 LAN (CN11) CN11 Part Number 1653205260 Footprint BH5X2SV Description BOX HEADER SMD 5 * 2 180D (M) 2.0 mm Pin Name +3.3V ACT# LINK# RXCT TXCT PCM-3342 User Manual...
A.16 PS2 (CN16) CN16 Part Number 1655306020 Footprint WHL6V-2M Description WAFER BOX 2.0 mm 6P 180D (M) W/LOCK Pin Name KBCLK KBDAT MSCLK +5 V MSDAT PCM-3342 User Manual...
ISA -5 V & -12 V Input (CN18) CN18 ISA -5 V & -12 V Input Part Number 1653003101 Footprint JH3X1V-2M Description PIN HEADER 3 * 1P 180D (M) 2.0 mm DIP SQUARE W/O Pb Pin Name -12 V -5 V PCM-3342 User Manual...
Need help?
Do you have a question about the PCM-3342 and is the answer not in the manual?
Questions and answers