Introduction; Installation Of Ethernet Driver; Installation For Ms-Dos And Windows 3.1 - Advantech PCM-5825 User Manual

Ns geode single board computer with cpu, 4 coms, vga/lcd, ethernet, and audio interface

Table of Contents

7.1

Introduction

The PCM-5825 is equipped with a high performance 32-bit Ethernet

chipset which is fully compliant with IEEE 802.3 100 Mbps CSMA/

CD standards. It is supported by major network operating systems. It

is also both 100Base-T and 10Base-T compatible. The medium type

can be configured via the RSET8139.exe program included on the

utility disk.

The Ethernet port provides a standard RJ-45 jack on board. The

network boot feature can be utilized by incorporating the boot ROM

image files for the appropriate network operating system. The boot

ROM BIOS files are combined with system BIOS, which can be

enabled/disabled in the BIOS setup.

7.2

Before installing the Ethernet driver, note the procedures below. You

must know which operating system you are using in your PCM-5825,

and then refer to the corresponding installation flow chart. Then just

follow the steps described in the flow chart. You will quickly and

successfully complete the installation, even if you are not familiar

with instructions for MS-DOS or Windows.

If you want to set up your Ethernet connection under the MS-DOS or

Windows 3.1 environment, you should first check your server system

model. For example, MS-NT, IBM-LAN server, and so on.

Then choose the correct driver to install in your panel PC.

The installation procedures for various servers can be found on CD-

ROM; the correct path being "D:\5825\Ethernet.100\wfw311".

7 4

PCM-5825 User's Manual

Table of Contents