Table of Contents
Advertisement
installation
|
54
FLUSH GLASS DOOR INSTALLATION
The standard flush door comes with a black frame. To install the frame,
simply hook the top door flange onto the top of the unit and swing the
door towards the unit, see Diagram 1.
OPTIONAL FINISHING TRIM INSTALLATION
1)
Install the Finishing Trim sides as shown in the diagram; line up the holes in the
side trim with the holes in the firebox side.
2)
Secure with 2 screws per side.
3)
Loosen the 3 screws in the top inside edge of the firebox.
4)
Slide the Finishing Trim Top over the Side Trim pieces and fit the
bottom bracket slots over the screws. Tighten the 2 screws to
secure in place.
Finishing Trim
54 |
Regency Bellavista® B41XTE -10 Gas Fireplace
918-791a
Diagram 1
OPTIONAL fINIshINg TrIm INsTALLATION
W
Edge of Unit
H
Be careful that the glass gasket does not roll up; there must be a gap
between the gasket and the door lip to ensure that the door sits securely
on the unit, see Diagram 2.
Use the hook to pull the spring out until you can put the hook into the
slot on the bottom door bracket. Repeat for 2nd spring. See Diagram 3.
To remove the flush door, reverse the above steps.
B41XTE
B36XTE
43-3/8"
40-1/2"
37-5/8"
35-3/4"
Diagram 2
B36XTe / B41XTe
Diagram 3
Finishing
Trim Top
Finishing
Trim Side
09/10/14
Advertisement
Table of Contents
