Regency Deuce Hugger Owner's Manual page 6

i
nstalling tHe
WARNING:
To avoid damaging the blades, do not install
them onto fan until fan is fastened to ceiling.
1. Carefully support the fan body (motor) in its styrofoam
packing with the top (where the wires come out) facing
upward.
2. Lift fan body to the hanging bracket and attach the
installation tether from the fan body to the mounting
plate for easier installation.
NOTE: The installation tether is a tool to assist during the
installation of the fan. It is not intended to be the only
means of supporting the fan. Care should be taken until the
fan is securely attached to the mounting plate. (Fig. 1).
Attach the Receiver (Fig. 2)
3. Connect the white wire from the outlet box to the white
wire on AC In side of the receiver.
4. Connect the black wire from the outlet box to the black
wire on the AC In side of the receiver.
5. Make wire connections (refer to page 6 "Electrical
Connections".)
6. Lift fan up to the hanging bracket aligning the keys on the
fan body with the mounting plate. Rotate clockwise a 1/4
turn until the screw holes in the fan body align with the
holes in the mounting plate. Attach the 3 screws to secure
the fan to the mounting plate. (Fig.3).
Black
Wire
Black
Wire
Receiver
Fig. 2
F
an
White Wire
Fig. 1
Fig. 3
5
Mtg. Plate
Tether Hole
Installation
Tether
Fan Body
Locking Tab
Mtg. Screw
Fan Body