Operation; Starting Up The Projector - BenQ W3000 User Manual

Operation

Starting up the projector

1. Plug the power cord into the projector and into
a wall socket. Turn on the wall socket switch
(where fitted). Check that the POWER
indicator light on the projector lights orange
after power has been applied.
Please use the original accessories (e.g. power cable)
only with the device to avoid possible dangers such as
electric shock and fire.
2. Press POWER on the projector
and a start up tone sounds. The POWER indicator light flashes green and stays
green when the projector is on.
The fans starts operating, and a start-up image display on the screen while it warms
up. The projector does not respond to further commands whiles it is warm up.
(If necessary) Rotate the focus ring to adjust the image clearness.
To turn off the ring tone, see
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
3. If this is the first time you turn on the projector, the setup wizard appears to guide
you through setting up the projector. If you have already done this, skip this step and
move on to step 5.
• Use the arrow keys (▲/▼/◄/►) on the projector or remote control to move
through the menu items.
• Use OK to confirm the selected menu item.
The Setup Wizard screenshots below are for reference only and may differ from the actual
design.
i. Specify Projector Position.
"Power On/Off Ring Tone" on page 59
For more information about
projector position, see
location" on page 16.
or remote control
"Choosing a
to start the projector
for details.
Operation 29