Operation; Starting Up The Projector - BenQ LK954ST User Manual

Operation

Starting up the projector

1. Plug the power cord. Turn on the power outlet switch
(where fitted). The power indicator on the projector
lights orange after power has been applied.
2. Press to start the projector. The power indicator
flashes green and stays green when the projector is on.
The start up procedure takes about 30 seconds. In the
later stage of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image
clearness.
3. If the projector is activated for the first time, select your
OSD language following the on-screen instructions.
4. If you are prompted for a password, press the arrow keys
to enter a 6-digit password. See
function on page
5. Switch all of the connected equipment on.
The projector will search for input signals. The current input
signal being scanned appears. If the projector does not detect
a valid signal, the message "No Signal" will continue displaying
until an input signal is found.
You can also press SOURCE to select your desired input signal. See
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before
energizing the lamp.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message
"Out of Range" displayed on the background screen. Please change to an input signal which is compatible with
the projector's resolution or set the input signal to a lower setting. See
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
20 Operation
Utilizing the password
22.
Switching input signal on page
Timing chart on page 56.
24.