BenQ W3000 User Manual page 37

Menu
3D Sync Invert
Settings
• 3D Sync Mode
• Projector
Position
• Test Pattern
• Auto Source
Search
• Menu Type
• HDMI Format
• Reset Lamp
Timer
• Reset All
Settings
• Information
Submenus and Descriptions
When your 3D image is distorted, enable this function to switch between
the image for the left eye and the right eye for the more comfortable 3D
viewing experience.
The function is accessible through the remote control.
Press OK to enter its submenu. See below for more details.
Selects a sync mode for your 3D glasses.
The projector can be installed on a ceiling or behind a screen, or with
one or more mirrors. See
Enables this function to display the grid test pattern, which helps you
adjust the image size and focus so as to check if the projected image is
free of distortion.
Sets whether the projector searches automatically for input sources.
Select On to enable the projector to scan for input sources until it
acquires a signal. If the function is set to Off, the projector selects the
last used input source.
Switches to the Advanced OSD menu.
Selects an input source type for the HDMI signal. You can also manually
select the source type. The different source types carry different
standards for the brightness level.
HDMI Format is only available when the HDMI signal is selected.
Activates this function only after a new lamp is installed. When you select
Reset, a "Reset Successfully" message displays to notify that the lamp
time has been reset to "0".
Returns all settings to the factory preset values.
The following settings will still remain: Keystone, Language,
Projector Position, and Reset Lamp Timer.
Displays the following information about your projector.
• Source: Displays the current signal source.
• Picture Mode: Displays the current Picture Mode.
• Resolution: Displays the native resolution of the input source.
• Color System: Displays input system format.
• Lamp Usage Time: Displays the number of hours the lamp has
been used.
• 3D Format: Displays the current 3D mode.
3D Format is only available when 3D Mode is enabled.
• Firmware Version: Displays the firmware version of your
projector.
Some information is given only when certain input sources are in
use.
"Choosing a location" on page 16 for details.
Menu Functions 37