Table of Contents
Advertisement
D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Troubleshooting Shift Problems
NOTE: The following information is provided to assist an installer in troubleshooting if hard
shifting or chucking/racheting is encountered when shifting into forward gear.
1. When installing the control box in the side panel of the boat, make sure that the cables
have enough clearance to operate. This is necessary because the cables move up and
down when the shift handle is moved. If the control box is mounted too far back toward
any fiberglass structure, the cables will be interfered with; this will cause very hard shift-
ing.
NOTE: The control box housing can be rotated in 30 increments to improve cable routing.
Proper Cable Bend
Improper Cable Bend
2. Ensure that when the shift cable from the control box is led through the side gunnel of
the hull, it does not have any extremely sharp bends in it as this will cause stiff shifting.
3. Before installing the shift cable into the control box, extend the stainless rod eye end of
the cable and grease it with 2-4-C Marine Lubricant. Move it back and forth
to allow even distribution of the grease.
Page 58 of 90
74688
74689
22005
Advertisement
Table of Contents
