Table of Contents
Advertisement
D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Steering System
NOTE: For Dual Installations, Power steering unit can be mounted on port or starboard
transom assembly. Measure exact distance between power package centerlines. Select a
tie bar from Quicksilver Accessory Guide. Refer to tie bar installation instructions before pro-
ceeding.
1. Inspect bushings for debris. Lubricate bushings with Special Lubricant 101.
2. Remove upper and lower pivot bolts and ensure threads are well lubricated with Special
Lubricant 101.
3. Install steering assembly as follows:
a. Position steering assembly so that pivot bolts will enter bushings in pivot block or
b. Install upper and lower pivot bolts along with tab washers. Ensure that tab washer
c. Turn pivot bolts all the way in by hand to ensure proper alignment.
d. Ensure steering assembly pivots freely.
Page 32 of 90
Bushings
a -
Special Lubricant 101
b -
power steering control valve.
tangs straddle the ridge on inner transom plate.
c
c
Tab Washers
a -
Ridge
b -
Pivot Bolts
c -
a
B
b
a
a
73898
73899
73900
Advertisement
Table of Contents
