Table of Contents
Advertisement
D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Inner Transom Plate
1. Insert wires, hoses and shift cable through appropriate openings in inner transom plate.
2. Position gimbal housing on transom and hold in place.
NOTE: When tightening transom assembly fasteners in the following step, start in the center
and, using a circular pattern, move outward. Tighten in small increments and go around the
pattern several times until the proper torque is achieved.
IMPORTANT: Steering lever continuity circuit wire must be positioned as shown to
avoid stressing wire when steering lever moves.
3. Secure transom assembly with hardware as shown. Torque to 20-25 Ib-ft (27-34 Nm).
Page 30 of 90
a
c
71626
a
70005
Locknuts and Flat Washers (8)
a -
Bolt
b -
Steering Lever Continuity Wire
c -
Transom Plate Continuity Wire
d -
b
d
71628
72043
a
71629
Advertisement
Table of Contents
