Reset A Running Programme Before The End; Automatic Programs; I.check; Care And Maintenance - Hisense HWFR6510 User's Operation Manual

Reset a running programme before the end

. .
The "Reset" button cancels a programme before the end.
Press the "Reset" button for at least 3 seconds.
Any existing water is drained out before the door can be opened.

Automatic Programs

The picture is only for reference and it might be different on each model
This washing machine provides 14 automatic programs. Turn the selector to
choose the right wash cycle for the type of fabric you are washing. These
program (depends on model availability) are including Cotton, Synthetics, Mix,
Quick, Silk/Delicate, Wool, Underwear, Big Items, Down Jacket, 95 Antibacterial,
Drum Clean, Rinse+Spin, Spin, and Daily Wash. Please refer to the following
chart for more information. Press the " Start/Pause "button to start the selected
wash cycle.
Status Light
The picture is only for reference and it might be different on each model
The status light as shown in above Figure verifies which portions of the washing
cycle the washer is operating. This also provides some fault information such as
"Clean Pump", "Water tap closed" and "Door Open". Please refer to the fault and
troubleshooting section for more information to solve the related fault.
I . Check
Self-diagnostic fault finding system which is called "I-Check" can detect the
incorrect operation and product fault automatically.
13

CARE AND MAINTENANCE

Appliance exterior and control panel

Could be washed down with a soft, damp cloth. A little neutral detergent
(nonabrasive) can also be used. Dry it with a soft cloth.
. .

Door seal

Clean with a damp cloth when it is necessary.
Cleaning the door seal also remove the door odour which could be caused by the
.
residual powder in the period of time.
Check the condition of the door seal periodically.
.

Filter

Check and clean the filter regularly, at least two or three times a year (see
.
"Removing the filter? section).
Do not use flammable fluids for cleaning the appliance.
. Drum Clean
After every 50 whole washing cycles, the indication light up for drum clean.
Empty the drum, close the door, select the " Drum Clean" program (depends on
model availability) and then press "Start/Pause "button.

Removing the Filter

We recommend that you check and clean the filter regularly, at least twice or three
times a year.
. .
Especially:
If the appliance is not draining properly or if it fails to perform spin cycles.
If the pump is blocked by a foreign body (e.g. buttons, coins or safety pins).
IMPORTANT: Ensure that the water has cooled before draining the
appliance .
1
Stop the appliance and unplug it.
Depending on the model, remove the plinth by holding it tightly on both
2
sides, pushing it downward and tilting it to the front. Or, push down on
the tabs provided on both the sides and remove it
3 Place a container beneath it to collect the drain water.
Take out the emergency hose and unplug it to drain the residual water to
4
the container (Fig. "b") .
Open the filter but do not remove it completely. Slowly turn the filter
5
counterclockwise until all the water has drained.
Unscrew the filter completely and remove it
6
Remove the external object to keep the filter and the filter chamber clean.
7
Check that the pump rotor moves freely
8
9 To re -insert the filter make sure the small lug/clip (as shown in the Fig. "d" ) is
facing up and then push the filter into the hosing first. After that start
screwing the filter in clockwise as far as it will go
Refix the emergency hose.
10
(Fig. "a") .
(Fig. "c") .
(Fig. "d") .
14