Detergent Dispenser; Water Supply Hose; Mesh Filter For Water Connection; Draining Residual Water - Hisense HWFR6510 User's Operation Manual

a
c
Pour about 1 litre of water into the detergent drawer to check that the filter
11
isinserted properly and securely.
Reinstall the plinth.
12
13 Plug in the appliance once again.
Select a programme and then press "Start/Pause"button.
14

Detergent dispenser

.
Press the release lever in the main wash compartment
.
downward and remove the drawer (Fig. "E").
Remove the cover grid from the fabric softener
.
compartment.
Remove the separator from the main wash compartment
. .
by pulling it upward (Fig. "F").
Wash all the parts under running water.
Refit the separator and the grid in the detergent drawer
and fit the drawer back inside its housing.
15

Water supply hose

Check the supply hose regularly for brittlenes s and cracks and replace it if
b
necessary using a new hose of the same type (available from After -Sales Service or
specialist dealer).

Mesh filter for water connection

Check and clean regularly.
For washing machines with an inlet hose as shown on
Fig."G".
d
. .
. .
. .
E

Draining residual water

Before emptying the residual water, switch the appliance off and unplug it from the
. .
mains socket. Remove the plinth. Place a container beneath it to collect the water.
F
. .
. .
.
. Before using the washing machine again:
Plug in the appliance once again.
G
Close the tap and loosen the inlet hose on the tap.
Clean the internal mesh filter and screw the water inlet hose back onto
the tap.
Now unscrew the inlet hose on the rear of the washing machine.
Pull off the mesh filter from the washing machine connection with
universal pliers and clean it.
Refit the mesh filter and screw the inlet hose on again.
Turn on the tap and ensure that the connections are completely water -
tight.
Take out the emergency hose and unplug it to drain the residual water .
Open the filter but do not remove it completely. Slowly turn the filter
counterclockwise until the water begins to drain out.
Wait until all the water has drained.
Now unscrew the filter completely and remove it.
Tilt the appliance forward carefully to allow the water to flow out.
Refit the filter and screw it in clockwise as far as it will go.
Refit the plinth.
Pour approx. 1 litre of water into the detergent drawer to check that the filter
is inserted properly and securely.
16