Detergents And Additives; Dosage; Stain Removal; Dyeing - Hisense HWFR6510 User's Operation Manual

DETERGENTS AND ADDITIVES

Always use high efficiency, low foam detergent for a front loadmachine.
. .
The choice of detergent depends on:
Type of fabric (cottons, easy care/synthetics, delicate items, wool)
. .
Colour
The wash temperature
Degree and type of soiling
Note: Use only specific detergents for washing wool
Remarks:
Any whitish residues on dark fabrics are caused by insoluble compounds used in
modern phosphate-free powder detergents. If this occurs, shake or brush out the
fabric or use liquid detergents. Use only detergents and additives specifically
produced for domes tic washing machines. When using descaling agents, dyes
or bleaches for the pre-wash, make sure that they are suitable foruse in domestic
washing machines. Descalers could contain products which could damage your
washing machine. Do not use any solvents (e.g. turpentine, benzine). Do not
machine wash fabrics that have been treated with solvents or flammable liquids.

Dosage

. .
Follow the dosage recommendations on the detergent pack. They dependon:
Degree and type of soiling.
. .
Size of wash.
Follow the detergent manufacturer's instructions for a full load.
. .
Half load: 3/4 of the amount of detergent used for a full load.
Minimum load (about 1 kg): 1/2 the amount of detergent used for a full load.
Depends on water hardness in your area (ask for information from your water
company) Soft water requires less detergent than hard water.
Notes:
Too much detergent can result in excess foam formation, which reduces washing
efficiency. If the washing machine detects too much foam, it may prevent
spinning. Insufficient detergent may result in grey laundry in time and also calcifies
the heating system, drum and hoses.
If you want to improve the rinse performance in the case of too much detergent
used.You can add the rinse times or press "Foam Clear" or "Spray" button
( Depend on models) before you start the program.

Stain removal

Blood, milk, eggs etc. are generally removed by the automatic enzyme phase of the
. programme.
To remove red wine, coffee, tea, grass and fruit stainsadd a stain remover to the
.
main wash chamber of the detergent dispenser.
Pre-treat heavily-soiled areas with stain remover if necessary.
7

Dyeing

. .
Only use dyes that are suitable for washing machines.
.
Follow the Manufacturers instructions.
Plastic and rubber parts of the washing machine can be stained by dyes.

Where to put detergent and additives

The detergent drawer has three chambers (Fig. "A") .
Prewash chamber
Detergent for the prewash / soak
. .
Mainwash chamber
Detergent for the main wash
.
Stain remover
Water softener (water hardness class 4)
Softener chamber
. .
Fabric softener
Liquid starch
Pour additives only up to the "MAX" mark.
How to position the separator in the main wash
chamber for powder or liquid detergent
For use with powder detergent: Place the separator inthe
higher position. Lift the separator until its top can be
reclined. Place its hooks on the upper end of the
backguide rails and slightly push the separator down to
fix it(Fig." " B and Fig." " C ).
A gap should remain between the separator and the bottom of the main wash
chamber, if the separator has been correctly installed (Fig. "B",and Fig. "C").
For use with liquid detergent: place the separator in the lower position. Secure the
separator in the chamber using the front guide rails. Position theseparator so that it
touches the bottom of the main wash chamber (Fig. "D") .
8