Table of Contents
Advertisement
Bend the cover back into position.
X
Tighten the two screws : again.
X
Side turn signal lamps
Insert a flat tool into recess : and lever
X
side turn signal lamp ; forwards and out.
Remove the bulb holder from side turn sig-
X
nal lamp ; by turning it a quarter turn
anti-clockwise.
Pull the bulb out of the bulb holder.
X
Insert the new bulb into the bulb holder.
X
Insert the bulb holder into side turn signal
X
lamp ; and turn it a quarter turn clock-
wise.
Insert side turn signal lamp ;.
X
Changing the rear bulbs
Tail lamp
Switch off the lights.
X
To remove: open the upper and lower tail-
X
gate (
page 57).
Y
Remove two screws : on the tail lamp using
X
a suitable slotted screwdriver.
Carefully take out the lamp.
X
To release the connector: insert a suitable
X
slotted screwdriver under the plastic
hanger, lift a small plastic piece upwards
and remove the connector.
Bulb holder
Tail lamp/brake lamp/side marker lamps
:
(only vehicles without partial LEDs)
;
Turn signal
Backup lamp
=
Rear foglamp (vehicles without partial
?
LEDs)
Unclip four bulb holder tabs A and care-
X
fully remove the bulb holder.
Pull out the corresponding bulb.
X
Insert the new bulb.
X
Re-install bulb holder.
X
Four bulb holder tabs A must audibly
engage.
Insert the connector.
X
Insert the lamp again.
X
Tighten the two screws : on the tail lamp
X
again.
Replacing bulbs
Z
73
Advertisement
Table of Contents
