Brake Lamps - SMART Fortwo 2015 Owner's Manual

X
Insert the bulb holder into side turn signal
lamp ; and turn it a quarter turn clock-
wise.
X
Insert side turn signal lamp ;.
Replacing the rear bulbs
Tail lamps
X
Switch off the lights.
X
To remove: open the upper and lower tail-
Y
gate ( page 62).
X
Remove two screws : on the tail lamp using
a suitable slotted screwdriver.
X
Carefully take out the lamp.
X
To release the connector: insert a suitable
slotted screwdriver under the plastic
hanger, lift a small plastic piece upwards
and remove the connector.
Bulb holder
Tail lamp/brake lamp (vehicles without
:
partial LEDs)
Turn signals
;
Reversing lamp
=
Rear foglamp (vehicles without partial
?
LEDs)
X
Unclip four bulb holder tabs A and care-
fully remove the bulb holder.
X
Pull the respective bulb out of bulb holder.
X
Insert the new bulb.
X
Insert the bulb holder again.
Four bulb holder tabs A must audibly
engage.
X
Insert the connector.
X
Insert the lamp again.
X
Tighten the two screws : on the tail lamp
again.
Licence plate lighting
X
To remove: release catch : of the lamp lens
using a suitable tool.
X
Remove the lamp lens.
X
Take bulb : out of the bulb holder.
X
Insert the new bulb.
X
Re-insert the lamp lens into the licence
plate lamp.
Replacing bulbs
Z
79