Table of Contents
Advertisement
Flat tire
162
G
WARNING
In the following situations, the tire seal-
ant is unable to provide sufficient break-
down assistance, as it is unable to seal the
tire properly:
there are cuts or punctures in the tire
R
larger than those mentioned above.
the wheel rim is damaged.
R
you have driven at very low tire pressures
R
or on a flat tire.
There is a risk of an accident.
Do not drive the vehicle. Contact a quali-
fied specialist workshop.
G
WARNING
The tire sealant is harmful and causes irri-
tation. It must not come into contact with
your skin, eyes or clothing or be swallowed.
Do not inhale TIREFIT fumes. Keep tire
sealant away from children. There is a risk
of injury.
If you come into contact with the tire seal-
ant, observe the following:
Rinse off the tire sealant from your skin
R
immediately with water.
If the tire sealant comes into contact
R
with your eyes, immediately rinse them
thoroughly with clean water.
If tire sealant is swallowed, immediately
R
rinse your mouth out thoroughly and
drink plenty of water. Do not induce vom-
iting, and seek medical attention imme-
diately.
Immediately change out of clothing
R
which has come into contact with tire
sealant.
If an allergic reaction occurs, seek med-
R
ical attention immediately.
!
Do not operate the tire inflation com-
pressor for longer than 15 minutes at a time
without a break. It may otherwise overheat.
The tire inflation compressor can be oper-
ated again once it has cooled down.
Comply with the manufacturer's safety
instructions on the sticker on the tire infla-
tion compressor.
Using the TIREFIT kit
Do not remove any foreign objects which
X
have penetrated the tire, e.g. screws or
nails.
Remove the tire sealant bottle and the tire
X
inflation compressor from the front-
passenger footwell (
Affix the 50 mph (80 km/h) maximum speed
X
sticker to the instrument cluster within the
driver's field of vision.
Unwind plug : with the cable from the tire
X
inflation compressor ;.
Remove hose A from the bottom section of
X
tire inflation compressor housing ;.
Remove cap on tire sealant bottle ? and
X
connect hose A.
Remove the cap from valve E on the faulty
X
tire.
Remove cap on filler hose = and screw
X
filler hose = onto the valve.
Insert connector : into the 12 V socket in
X
your vehicle (
page 147).
Y
page 161).
Y
Advertisement
Table of Contents
