Error Messages; Hata Mesajları; Μηνύματα Σφάλματος; Mesaje De Eroare - Epson Stylus Photo PX700W series Basic Operation Manual

Error Messages

Hata Mesajları
Μηνύματα
σφάλματος

Mesaje de eroare

& 80
R
EN
& 81
R
TR
& 82
R
EL
& 83
R
RO
0
EN
Error Messages
Paper is jammed in the printer. Turn off the printer,
open the scanner unit, and remove the paper. See your
documentation.
A printer error has occurred. Turn off the printer and turn
it on again. Please see your documentation.
Cannot recognize photos. Make sure photos are placed
correctly. See your documentation.
A scanner error has occurred. See your documentation.
The printer's ink pads are nearing the end of their
service life. Contact Epson Support.
The printer's ink pads are at the end of their service life.
Please contact Epson Support.
The print head cannot be cleaned completely with Auto
Head Maintenance. See your documentation.
The data is too complex to print with Bluetooth.
Error in the data. The document cannot be printed.
Error in the data. The document may not be printed
correctly.
Backup Error.
Error Code xxxxxxxx
The combination of IP address and subnet mask is
invalid. See your documentation.
Solution
& 92
R
& 94
R
& 26
R
Turn the printer off and then back on. If the error message still appears,
contact your dealer.
Contact Epson support to replace ink pads before the end of their
service life. When the ink pads are saturated, the printer stops and Epson
support is required to continue printing.
Contact Epson support to replace ink pads.
After cleaning, check the print head from the Maintenance menu in
Setup mode. If quality has not improved, contact Epson support for
repairs. If nozzles are still clogged you can continue printing by setting
Automatic Head Maintenance to off from the Maintenance menu in
Setup mode.
See the documentation for the device transmitting the data.
See the documentation for the device transmitting the data. (Cause: The
data is not available because of a malfunction in the device.)
See the documentation for the device transmitting the data. (Cause: A
part of the data is corrupted or cannot be buffered.)
A problem occurred and backup was canceled. Make a note of the error
code and contact your dealer.
Refer the online User's Guide - Networking.