Table of Contents
Advertisement
4.3
Care
4.3.1 Seat and back cushion
The cleaning of the seat and back cushion shall done as follows:
Clean the seat and back cushion with a cloth moistened in hot water. Take
care that you do not soak the cover.
Use a mild commercial detergent for removing stubborn dirt.
Stains can be removed by using a sponge or a soft brush.
Do not use strong cleaning liquids like solvents, nor use hard brushes.
Never clean with steam and/or pressure washers.
Damage caused by the use of improper cleaning agents is not the responsibility of
Vermeiren.
4.3.2 Plastic parts
Clean plastic parts of your electric wheelchair with commercial plastic cleaners. Only use a
soft brush or soft sponge. Take note of special product information.
Examples of plastic parts are the footplates, control box, etc.
4.3.3 Coating
The high quality of the surface layer guarantees optimal protection against corrosion. If the
outer coating is damaged by scratching or in some other way, get your specialist dealer to
repair the affected surface.
When cleaning, only use warm water and normal household detergents and soft brushes and
cloths. Ensure that no moisture gets into the components (tubes, electronics, ...).
Initially the chrome parts only require rubbing with a dry cloth. Dull places or stubborn dirt can
best be removed by using a suitable commercial chrome polish.
Dulling can be avoided by lightly greasing steel parts with Vaseline.
4.3.4 Electronics
L
WARNING:
Check the plug connectors for corrosion or damage before every ride,
since it could affect the efficiency of the electronics.
L
WARNING:
Remove the batteries before performing any maintenance, to avoid
involuntary conduction of currents.
Wipe the control unit with a cloth moistened by a few drops of a commercial domestic
cleaner. Do not use any abrasives or sharp-edged polishing equipment like a metal scrubber
or brush, since these can scratch the surface of the operator control.
Page 32
Navix
2012-04
Advertisement
Table of Contents
