Adjusting The Seat Width - Vermeiren Navix Instruction Manual

3.3.3 Adjusting the seat width

L L L L
WARNING:
Risk of tipping over - Check that the arm supports and footrests are
positioned identically on each side.
The seat width can be adjusted over a range of 50 mm by moving the arm supports and
footrest in horizontal direction.
* Adjusting arm supports:
1. Loosen the hexagon socket set screws Ⓐ
just under the seat frame on each side.
2. Move the arm support in an horizontal
direction until the correct seat with, by
moving the square tubes Ⓑ and Ⓒ over
each other.
3. Retighten the screws Ⓐ properly.
4. Repeat instructions above for the other arm
support.
The maximum position of the seat width is
marked with the triangle on the square tube
Ⓐ Ⓐ Ⓐ Ⓐ . Place the point of the triangle against the
square tube Ⓑ Ⓑ Ⓑ Ⓑ mounted on the seat frame.
The minimum position of the seat width is
when the triangle edge of part Ⓐ Ⓐ Ⓐ Ⓐ is against
the square tube Ⓑ Ⓑ Ⓑ Ⓑ mounted on the seat
frame.
Page 26
Navix
2012-04