2.23 Thermal fuse
For the seat heights 400 and 450 mm the occupant or attendant can operate the
thermal fuse.
For the seat height 500 mm only the attendant can operate the thermal fuse.
To be able to use the electric wheelchair again, remove the overload and wait till the motor
has cooled down. Then gently press the thermal safety mechanism back in. Your wheelchair
is now ready for use again.
3
Installation and adjustment
The instructions in this chapter are for the specialist dealer only.
The Navix has been designed as a front wheel drive electric wheelchair. The advantage of
this wheelchair is a better maneuverability.
L L L L
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L L L L
WARNING:
Risk of tipping over - Variation allowed adjustments can still change
the stability of your wheelchair (tilt back or sideways).
3.1
Tools
The Vermeiren Navix shall be delivered with:
•
Wrench set n° 10 to n° 19
•
Allen keyset n° 3 to n° 5
•
Screwdriver Phillips head
3.2
Manner of delivery
The electric wheelchair shall be delivered with:
•
1 seat and lower frame with arm supports, operator control, rear and front wheels
•
1 pair of footrests
•
2 x drive batteries, 2 x drive motors
•
Impulse S charger (6A) + manual of Impulse S charger
•
Electronics
•
Tools
•
Manual + manual operator control
•
Accessories
Before use, check that everything is included and that no products are damaged (example
by transport, ...).
To protect the motor against overload, on the
front side of the battery housing there is a
thermal
safety
mechanism
automatically cut off the motor to prevent
overheating and thus rapid wear and tear or
breakdowns. This can occur if you go up or down
slopes that exceed the maximum gradient
indicated.
Nominal
maximum
could
mechanism.
Page 23
2012-04
that
loads
exceeding
also
trigger
the
Navix
will
the
safety