CanyCom CMX 224 Operator's Manual page 23

2
10 Cutting Height Adjust . . . . Cutting height adjust lever is used to adjust the cutting
Lever
11 Cutting Height Adjust
Lock
12 Cutting Rotary Clutch . . . . Cutting rotary clutch lever is used to start or stop rotating
Lever
13 Tilt Lever . . . . . . . . . . . . . . . Tilt lever is used to adjust the angle of steering wheel.
(CMX224 Only)
14 Head Lamp Switch . . . . . . . Head lamp switch is used to turn on or off head lamp.
15 Tail Lamp Switch . . . . . . . . Tail lamp switch is used to turn on or off tail lamp. When
16 Fuel Gauge . . . . . . . . . . . . . Fuel gauge indicates the amount of fuel in fuel tank.
17 Hour Meter . . . . . . . . . . . . . Hour meter indicates the cumulative total operating time of
Controls and Components
height. Grab and hold cutting height adjust lock and move
cutting height adjust lever back or forth to adjust cutting
height.
cutting rotary.
When umain switch is on, head lamp switch illuminates.
umain switch is on, head lamp switch illuminates.
the machine in 0.1 hour increments.
-14-