Elation Design Wash 575E User Instructions page 31

Hide thumbs Also See for Design Wash 575E:

Table of Contents

approximate size of the room (NORM, BIG, MIDL, SMAL). The built-in programs

will automatically adjust to your selection to optimize light output for your room.

9.2.1 Use the sound sensitivity knob on the side control panel to make the unit more

or less sensitive to sound. Turning the knob in clockwise direction will make the

unit more sensitive to sound, while turning the knob counter-clockwise will make

the unit less sensitive to sound. Note: This unit will react to the low frequencies

of a sound source, tapping on the fixture or high pitched sound may not trigger

the fixture.

9.2 Master-Slave Operation (Sound Active): This function will allow you to link up to

16 fixtures together and operate without a controller. The fixtures will be sound

activated. In Master-Slave operation one fixture will act as the controlling fixture and

the others will react to the controlling fixtures programs. Any fixture can act as a

Master or as a Slave.

9.2.1 Using standard XLR microphone cables, daisy chain your fixtures together via

the XLR connector on the rear of the fixtures. Remember the Male XLR

connector is the input and the Female XLR connector is the output. The first

fixture in the chain (master) will use the female XLR connector only - The last

fixture in the chain will use the male XLR connector only. For longer cable runs

we suggest a terminator at the last fixture.

9.2.2 Follow the same procedures listed in the previous Stand-Alone section. With

two exceptions; Be sure the first unit in the chain is selected as the

"master"(MSTR) is turned on in the audio submenu. All other fixtures must be

in "slave" mode (SVPT) turned on in the audio submenu.

Design Wash 575E™

Table of Contents