Raymarine i40 Installation And Operation Instructions Manual page 26

Item Cable color
1 Black
2 Blue
3 Screen
i40 Speed connection
Item Cable color
1 Brown
2 White
3
Screen
4 Green
5 Red
i40 Wind connection
Item Cable color
1 Red
2 Blue
Making transducer connections
Although the transducer cable is fitted with spade
connectors for direct connection to the rear of the
unit, it may be necessary to remove these to facilitate
installation, e.g. if the cable has to be routed through
narrow apertures. 1/8th spade terminals will be
26
Signal name
Piezoceramic –
Piezoceramic +
0 V (shield)
1 2 3 4 5
Signal name
Temperature 0 V
Temperature
(signal)
Speed 0 V (shield)
Speed (signal)
Speed V+
1
2
Signal name
Rotor +
Rotor –
required (not supplied), to replace those removed.
When fitting the new spade connectors, prepare the
cables as detailed below:
1
2
1. Prepare the cable as shown in 1 above.
2. Fold back the wire strands and insert into the new
spade connector as shown in 2 above.
3. Ensure the wire strands do not extend beyond
the rear of the spade connector insulation.
4. Crimp the connector to the wire.
D12352-1
D12353-1
6 mm
50 mm
D12359-1
i40