ECS GF8200SM-M3 User Manual page 61

b Select "NVIDIA RAID CLASS DRIVER (required)" and then press Enter.
c Press S again at the Specify Devices screen, then press Enter.
d Select "NVIDIA NForce Storage Controller (required)" and then press
Enter.
The following Windows Setup screen appears listing both drivers:.
Figure 1.13 Windows Setup—NVIDIA drives listed
5 Press Enter to continue with Windows XP Installation.
Be sure to leave the floppy disk inserted in the floppy drive until the blue
screen portion of Windows XP installation is completed, then take out the
floppy.
6
Follow the instructions on how to install Windows XP.
After Windows XP is completely installed, it is recommended that you
install the ForceWare software in order to access the MediaShield RAID
Management tool.
Each time you add a new hard drive to a RAID array, the RAID driver
Note:
will have to be installed under Windows once for that hard drive. After
that, the driver will not have to be installed.
This concludes chapter 5.
NVIDIA RAID Configuration
57