Checking Jumper Settings; Jumper Settings - ECS GF8200SM-M3 User Manual

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.

Jumper Settings

Jumper Type Description
CLR_CMOS 3-pin CLEAR CMOS
Rear USB/PS2
3-pin
USBPWR_R1~2
Power Select
Jumper
Front Panel
USBPWR_F1~2 3-pin
USB Power
Select Jumper
1. To avoid the system instability after clearing CMOS, we recommend
users to enter the main BIOS setting page to "Load Optimized Defaults"
and then "Save & Exit Setup".
2. Make sure the power supply provides enough VCC5_DUAL voltage
before selecting the VCC5_DUAL function.
3. It is required that users place the USBPWR_F & USBPWR_R cap onto
2-3 pin rather than 1-2 pin as default if you want to wake up the
computer by USB/PS2 KB/Mouse.
Installing the Motherboard
Setting (default)
1-2: NORMAL
2-3: CLEAR
1
Before clearing the
CMOS, make sure to
CLR_CMOS
turn the system off.
1
1-2: VCC5
2-3: VCC5_DUAL
USBPWR_R1~2
1-2: VCC5
1
2-3: VCC5_DUAL
USBPWR_F1~2
9