Integrated Peripherals - ECS GF8200SM-M3 User Manual

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
Onboard IDE Controller
OnChip S-ATA Controller
SATA Mode select
Onboard AUDIO Function
Onboard LAN Function
Onboard LAN Boot ROM
Serial Port1 Address
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
USB Controller
Legacy USB Support
: Move Enter : Select
< >
F1: General Help
Onboard IDE Controller (Enabled)
Use this item to enable or disable the onboard IDE interface.
Onboard S-ATA Controller (Enabled)
This item allows you to enable or disable the onboard SATA controller.
SATA Mode select (SATA Mode)
Use this item to select the mode of the Serial ATA.
Onboard AUDIO Function (Enabled)
Use this item to enable or disable the onboard Audio function.
Onboard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Onboard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can select Normal (Standard
Parallel Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or
BPP (Bi-Directional Parallel Port).
ECP Mode DMA Channel (DMA3)
Use this item to assign the DMA Channel under ECP Mode function.
Integrated Peripherals
Enabled
Help Item
Enabled
SATA Mode
Enabled
Enabled
Disabled
3F8/IRQ4
378
ECP
DMA3
IRQ7
Enabled
Enabled
+/-/: Value F10: Save ESC: Exit
F9: Load Default settings
Using BIOS
35