Table of Contents
Advertisement
Model SC-VHD-HDMI
3.3 Setting the Output Resolution
3.3.1 Obtaining an image on the screen
As shipped from the factory, or after a factory default reset, the
unit output resolution setting should be "NATIVE". This means
that upon power up the device will read the EDID of your display
and output a compatible resolution resulting in a picture.
However, if the output setting is not at "NATIVE", or if the unit
cannot ascertain the EDID of the display, then you may not get a
picture and since most settings are done by means of an on-
screen display (OSD), it is necessary to get an image on the
display first.
For this purpose, you can use one of two preset button
combinations to set a resolution that your display supports. Two
options are available (depending on the display device):
1. If the display is HDTV compatible (with an HDMI connection);
then a resolution of 480p should result in an image.
2. If the display is PC compatible (DVI), then XGA (1024x768)
should result an image.
Once you have an image, you can call up the OSD menu to
make further changes if necessary.
At any time, pressing the UP ARROW
together will change the output resolution to 1024x768 @ 60 Hz.
Pressing the MENU and DOWN ARROW
the output resolution to 480P @ 60 Hz.
3.3.2 Recalling Factory Defaults
Factory defaults may be recalled via (2) methods:
1. Press the MENU button to display the OSD. Using the
arrows buttons, move to highlight the 'FACTORY RESET'
option and press the MENU button. The unit will reset all
parameters to the factory defaults. The output resolution will
be set at 'NATIVE', which should result in a picture being
displayed. The actual resolution of the display monitor in
this mode is dependant on the monitor and not the SC-VHD-
HDMI.
2. Unplug the DC jack from the unit. Press and hold the menu
button and simultaneously plug the DC jack. This causes all
parameters to revert to factory defaults.
6
and MENU button
together will change
Advertisement
Table of Contents
