2.2.13. MJR PC Board (1003), Power Supply Unit (1002)
(2)
(4)
(5)
(6)x5
(7)
(8)
(11)
(9)x4
(8)
(3)
(10)
Caution:
Make sure the Power Cord (1108) is unplugged.
Note:
If removing only the Power Supply Unit, skip step
(3), (4) and (5).
(1) Remove the Rear Cover (105) (Refer to 2.2.12.).
(2) Disconnect the Connectors (CN28 and 29) on
the MJR PC Board.
(3) Remove 2 Screws (19).
(4) Release the Latch Hook of Locking Card
Spacer (405).
(5) Remove the MJR PC Board (1003).
(6) Remove 5 Screws (19).
(7) Remove the L Power Plate (401).
(8) Disconnect the Connectors (CN101, 102, 103,
201 and 202) on the Power Supply Unit (1002).
(9) Remove 4 Screws (19).
(10) Remove 1 Screw (19) and 1 Washer (G8).
(11) Remove the Power Supply Unit (1002).
35