Panasonic UF-580 Service Manual page 261

No. Parameter
34 ENERGY SAVER
MODE
35 DAYLIGHT TIME
36 RING PATTERN
DETECT (DRD)
(See Note 2)
37 RCV TO MEMORY
38 ACCESS CODE
39 PIN CODE ACCESS
42 CONF. POLLED FILE
SAVE
43 PASSWORD-XMT
44 PASSWORD-RCV
46 SELECT RCV
47 REMOTE RECEPTION
51 REMOTE
DIAGNOSTIC
Setting
Setting
Number
1 Off
2 Energy-
Saver
*3 Sleep
1 Invalid
*2 Valid
*1 Invalid
2 Valid
(----)
(----)
*1 None
2 Suffix
3 Prefix
*1 Invalid
2 Valid
*1 Off
2 On
*1 Off
2 On
*1 Invalid
2 Valid
1 Invalid
*2 Valid
*1 Invalid
2 Valid
261
Comments
To reduce the power consumption in standby, select either
Energy-Saver or Sleep mode and specify the Delay Time
(1 to 120 minutes) for the machine to enter into the
selected mode.
The Delay Timer setting is only available in the Energy-
Saver or Sleep Modes.
Off : The unit will remain in standby
mode and consume more energy
than when in Energy-Saver or
Sleep modes.
Energy-Saver Mode : Saves energy by consuming less
power than when in standby mode
by turning off the fuser unit after the
specified time.
Sleep Mode : This is the lowest power state that
the machine enters after the
specified time without actually
turning off.
Selecting whether the clock adjusts for Daylight Saving
Time automatically. The built-in clock will advance 1 hour
at 2:00 am on the first Sunday in April and fallback 1 hour
at 2:00 am on the last Sunday in October.
All ring patterns.
Select a ring pattern for automatic answering.
1: A Standard ring pattern.
2: B Double ring pattern.
3: C Triple ring pattern (Short-Short-Long).
4: D All other triple ring patterns, except the
type C described above.
Enter a 4-digit password used to print out the received
document in memory by using F8-5 (RCV TO MEMORY).
When F8-5 is set to On, this parameter will not be shown
on the LCD display.
Enter a 4-digit Access Code to secure the machine from
unauthorized use.
Selecting the access method (Prefix or Suffix) to dial a
number with PIN Code.
Selecting whether the machine saves the confidential
polled file even after the file is polled once.
Setting a 4-digit XMT-Password and selecting whether the
machine performs and checks the XMT-Password of the
receiving station when transmitting.
Setting a 4-digit RCV-Password and selecting whether the
machine performs and checks the RCV-Password of the
transmitting station when receiving.
Selecting whether the machine performs selective
reception.
Selecting whether or not the machine accepts remote
reception command.
Selecting whether or not the machine accepts to update
the firmware or Remote Diagnostics from the remote
station. Please ask your Panasonic Authorized Dealer for
details.